If you are reading this, you must be a new DIYer with a drill in your hand for the first time, or you have just thrown your drilling set away because you don’t know how to drill in the right ways. Don’t worry! This article will show you some drilling tips that can help you make the most of this great tool.
1. Mark the spot and start slow
Before drilling, you should use trim nails to make a small depression to mark the drilling spot. This will create a comfortable place for the drill bits to land and ensure the drill will not spin off the place.
To boost your accuracy while drilling, you should also start with slow RPM as it gives you better control at the start and prevents the drill bits from being off the spot.
2. Step up the drill bits size
If you want to drill a big hole, you should start with a small drill bit to create a narrower hole first. Then you can use the exact drill bit size you need to widen the hole. This method will be helpful for beginner because it’s easier to drill two small holes than to control a large hole at once, and it can make the hole more smooth and clean.
3. Apply enough pressure
This is the most challenging skill for a beginner to learn, as applying the wrong amount of force is the most serious mistakes that a driller can make. You will want to believe in the power of your drill machine and let it do its job. Remember that it is designed and produced to cut through hard materials. If you push the drill with too much pressure, it can cause damages to the drilling material and even harm your drill bit.
4. Use tape to prevent drilling too deep
Overdrilling or drilling through the backside of the material is a severe mistake that can harm your table, material, and drill bits.
To ensure that you drill with the correct depth, you should use tape to mark the depth on your drill bit. As long as you keep the part covered by the tape on your sight, the hole you drill will have precisely the depth you want.
5. Drill in the right angle
Several beginners make mistakes about the angle of the hole, as they seem to pay too much attention to the pressure they put on the drill and forget to control the angle. If you want to drill a straight hole, keep a straight angle and pay attention to it until the hole is finished.
Drilling with an angle is more complicated, so beginners should practice more before trying. It would help if you started with a straight angle, then change to the angle you want. It’s similar to the first tip as it creates a comfortable place for the drill bit to land, prevents it from spinning off the spot.